This is an archived forum community. It's currently closed to new memberships.
ElantraClub - for all generations

Welcome Guest ( Log In | Register )


Recent edits
Shark Racing Cr... by elantragt
  Dec 25 2016, 09:01 PM
Audio Buying ti... by elantragt
  Dec 23 2016, 03:16 PM
Basic cleaning ... by elantragt
  Dec 22 2016, 12:05 PM
Adding LED'... by elantragt
  Dec 22 2016, 11:57 AM
Solid Motor Mou... by elantragt
  Dec 22 2016, 11:46 AM
Body color head... by elantragt
  Dec 22 2016, 11:41 AM

Stats
Our members have created a total of 137 articles in 13 categories.

A total of 602 edits have been made and our articles have been viewed 1,715,103 times

> Lug Stud Replacement DIY , by 2000J25SP
Options V
Jack the car up



Remove the wheel. (21 mm)



Remove upper caliper bolt. (17mm)



Remove lower caliper bolt. (17mm)



Remove the caliper. Use some wire and hang it from the coil spring. DO NOT leave the caliper hanging by the brake line!!!




With the caliper off, you can push the lug stud out.




Get a hammer and hit the lug stud. It might take a few hits before it comes loose.



Removed



Push the new lug stud by hand. Then tighten a lug nut onto the stud, while using your other hand to press on the back of the stud to prevent it from spinning. You might need some washers if your lug nut isn't deep enough to press the stud into the hub.





Reinstall everything. Torque lugs to spec.

Caliper Assembly to Knuckle: 51-63 ft-lb / 69-85 N-m
Lug Nuts: 65-80 ft-lb / 88-108 N-m

Last update: Jun 8 2013, 11:13 PM by Doohickie    Created: Jun 8 2013, 09:04 PM by elantragt    Edits: 3    Views: 4,355
Print article  Download MSWord version  Download txt version
Visit this article's discussion topic

Copyright 2022 The Elantra Club    
Time is now: 14th April 2024 - 04:36 PM
Elantra Club is not affiliated in any way with Hyundai Motor America