This is an archived forum community. It's currently closed to new memberships.
ElantraClub - for all generations

Welcome Guest ( Log In | Register )

Recent edits
Shark Racing Cr... by elantragt
  Dec 25 2016, 09:01 PM
Audio Buying ti... by elantragt
  Dec 23 2016, 03:16 PM
Basic cleaning ... by elantragt
  Dec 22 2016, 12:05 PM
Adding LED'... by elantragt
  Dec 22 2016, 11:57 AM
Solid Motor Mou... by elantragt
  Dec 22 2016, 11:46 AM
Body color head... by elantragt
  Dec 22 2016, 11:41 AM

Our members have created a total of 137 articles in 13 categories.

A total of 602 edits have been made and our articles have been viewed 1,868,608 times

> Component speaker install in the MD/UD , by silvergls
Options V
Infinity Reference 6030cs install

Woofer comparison

Stock Woofer removal:
Only hand tools were used
Diagonal wire cutter, used to cut and seperate the speaker's brackets
Scissors, to trim the rubber surrounds from the speaker cone (left the rubber surrounds to help cushion the Infinity woofer)

Infinity Woofer installed to stock speaker spacers
Only 4 drilled holes were needed for mounting. Speaker adapters were not used.

Stock vs Infinity tweeters installed

Infinity tweeter and Crossover installed

Input wiring using the factory tweeter connector removed from the tweeter as input to the crossover. Only the tweeters door wiring is used as input, the woofers are disconnected. The factory system does not have a dedicated signal to the woofer and tweeter. Infinity woofers wiring is tied to the center connectors on the crossover.
Space and location for the crossover was perfect.

Woofer installed

Some tips on the front panel removal

Front door panel removal:

First roll down the windows
Remove side mirror panel. Pry off, it's held on by snap clips

Remove 2 phillips screws by first popping the covers loose.

Remove the door panel by prying and grabbing at the gap bellow the foward portion of the panel. Start from there and work your way around the entire panel. Panel is held in with push pins.

Carefully raise the panel from the window seal starting from the rear. Hold the panel slightly away from the door and remove the electrical wiring harnesses and door latch clips attached to the panel.

Door latch assembly

Panel removal done.

Take note that reassembly is just as easy if not easier. If you have trouble, don't force it as everything goes together rather quickly. Test door handle and locks once the panel is in place.

Last update: Jul 19 2011, 02:38 PM by elantragt    Created: Jul 16 2011, 08:24 PM by elantragt    Edits: 2    Views: 4,406
Print article  Download MSWord version  Download txt version
Visit this article's discussion topic

Copyright 2022 The Elantra Club    
Time is now: 14th June 2024 - 04:08 AM
Elantra Club is not affiliated in any way with Hyundai Motor America