Infinity Reference 6030cs install



Woofer comparison


Stock Woofer removal:
Only hand tools were used
Diagonal wire cutter, used to cut and seperate the speaker's brackets
Scissors, to trim the rubber surrounds from the speaker cone (left the rubber surrounds to help cushion the Infinity woofer)


Infinity Woofer installed to stock speaker spacers
Only 4 drilled holes were needed for mounting. Speaker adapters were not used.


Stock vs Infinity tweeters installed


Infinity tweeter and Crossover installed

Input wiring using the factory tweeter connector removed from the tweeter as input to the crossover. Only the tweeters door wiring is used as input, the woofers are disconnected. The factory system does not have a dedicated signal to the woofer and tweeter. Infinity woofers wiring is tied to the center connectors on the crossover.
Space and location for the crossover was perfect.



Woofer installed



Some tips on the front panel removal

Front door panel removal:

First roll down the windows
Remove side mirror panel. Pry off, it's held on by snap clips


Remove 2 phillips screws by first popping the covers loose.


Remove the door panel by prying and grabbing at the gap bellow the foward portion of the panel. Start from there and work your way around the entire panel. Panel is held in with push pins.


Carefully raise the panel from the window seal starting from the rear. Hold the panel slightly away from the door and remove the electrical wiring harnesses and door latch clips attached to the panel.


Door latch assembly

Panel removal done.

Take note that reassembly is just as easy if not easier. If you have trouble, don't force it as everything goes together rather quickly. Test door handle and locks once the panel is in place.